Ford Focus PATS Disable/Reset 

Did you recently replace a PCM/ECU only to find that the engine started then died, even after the computer was properly reprogrammed? Chances are the security system (PATS) is not properly married. This service is for the removal of the PATS security programming found on Ford engine computers.

What MoPower Can Offer
We reprogram Ford computers to remove the PATS feature then rewrite the VIN back to the computer. This will be a permanent solution for PCM replacements that had no start conditions. If you would like to remove PATS from a car, with a failing PATS module, you must first unplug the PATS module before installing a PCM that has had the PATS security cleared. The PATS  must remain unplugged for the PATS  feature to remain inactive.

How SKIM Works
Every Ford PCM is capable of SKIM security, even if the vehicle is not equipped. The computer looks for the PATS security signal when the key is turned on. If that signal is found, PATS security is now activated in the PCM and the computer will now always look for the PATS module. PATS cleared PCM's can also be started with both security and non-security keys.

Security Light Woes
Cars equipped with PATS that have had security deleted, you will find the security light may illuminate. Unfortunately, the only solution for this is to remove the security light from the speedometer or dash. (most common in Jeeps)

Is This Service Plug-n-Play?
For most customers, the PATS cleared PCM can be installed with no additional procedures. Some users may find that a global code clear may be required before the vehicle will start.

Please make sure to include Full Name, Address and VIN number in the box with the ECU. Failure to do so will result in delays.